Myers 10MPB200-02, High Pressure Booster Pump, MPB Series, 2 HP, 115/230 Volts, 1 Phase, 16 Stages, 3/4" NPT Discharge, 3/4" NPT Suction, 10 GPM Best Efficiency Flow, 15 GPM Max., 690 ft. Max. Head, Stainless Steel Body
Myers 10MPB200-02, High Pressure Booster Pump, MPB Series, 2 HP, 115/230 Volts, 1 Phase, 16 Stages, 3/4" NPT Discharge, 3/4" NPT Suction, 10 GPM Best Efficiency Flow, 15 GPM Max., 690 ft. Max. Head, Stainless Steel Body
SKU #: 10MPB200-02
Brand: Myers
Available For Order! ((Usually Ships 3-5 Days))This product is direct shipped from the manufacturer. The estimated shipping time may vary depending on the manufacturers stock, backlog or delay. If you would like to confirm the manufacturers lead time for this item, call our Pump Products sales team at 800-429-0800 between the hours of 7:30 A.M. - 4:30 P.M. E.S.T. FREE SHIPPING ON THIS ITEM ! Offer applies to the lower 48 states and excludes Alaska, Hawaii, APO/FPO and international orders. Free standard shipping applies to U.S. orders only and to select items that meet UPS Standard Ground container/cube requirements. Free Shipping
Some manufacturers require internet retailers to display a price at or above manufacturers established MAP ("Minimum Advertised Price").
Since our price for this product is lower than MAP, the manufacturer does not allow us to display our lowest price until you place the product in the shopping cart. This allows us to continue offering our lowest prices while staying consistent with product manufacturers policy.
This process does not require you to purchase the product - it can be easily removed from shopping cart if needed.
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Call Toll Free: 800-429-0800
"Ask Inspector PumpHead"
Our Friendly Staff At PumpProducts.com Can Assist You In Placing Your Order.
Sales Representatives Available!
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Myer MPB Series Serviceable High Pressure Booster Pump
This booster pump is the most durable booster pump available at Myers. The proven SignaSeal floating impeller design minimizes thrust loads allowing for continuous operation without damage to motor bearings, mechanical seal or pump hydraulic components.
Features
Cast iron motor adapter and base for maximum corrosion resistance; one-piece threaded shaft for positive impeller drive
Max. inlet pressure of 80 PSI
Max. working pressure of 315 PSI
Max. suction lift of 15 feet
Prolonged use with liquids above 140° F is not recommended
Cast iron discharge
300 series stainless steel shell
Staging system uses independent floating precision-molded acetal impellers for superior sand handling, perfect balance, and ultra-smooth for highest performance and efficiency
Polycarbonate diffuser for superior performance with high resistance to corrosion and abrasion
300 series stainless steel body and shaft
Mechanical seal is made of Carbon/ceramic, Buna-N
Buna-N O-rings
Balanced Rotor – Die cast under high pressures for uniform performance and greater efficiency; dynamically balanced
Shielded, permanently lubricated bearings, extensively tested to ensure extended life and smooth, quiet operation
Applications
Car wash
Filtration
Reverse osmosis
Residential, commercial or agricultural pressure washing
