Zoeller 137-0036, Model F137, Series 130, Sump & Effluent Pump, 1/2 HP, 230 Volts, 3 Phase, Manual, Cast Iron, 1-1/2 Inch Discharge, 15 Ft. Cord

FEATURES

Zoeller "Flow-Mate" Effluent Pump

This effluent or dewatering submersible pump is used for septic tank, low pressure pipe (LPP) and enhanced flow STEP systems.These durable cast iron pumps include a powder coated epoxy finish to prevent corrosion and are designed to provide great heat dissipation from the motor, ensuring a long service life. As with every Zoeller pump, each one is 100% pressure-tested, submerged and run to ensure quality and reliability for years of trouble-free performance! This attention to detail is an inherent feature of every pump in this series, making it one of the most reliable in the industry. The sizing of effluent systems normally requires variable level float(s) controls and properly sized basins to achieve required pumping cycles or dosing timers with non-automatic pumps.

Features

• All cast iron ASTM class 25, 2500# tensile strength
• Corrosion-resistant, powder coated epoxy finish 
• Durable, cast iron construction - switch case motor and pump housing, base and impeller
• No sheet metal parts to rust or corrode
• Upper and lower sleeve bearings running in bath of oil
• Carbon and ceramic shaft seal
• Stainless steel screws, bolts, guard, handle, arm and seal assembly
• Maximum temperature for effluent or dewatering: 130°F 
• Passes 5/8" spherical solids
• No screens to clog
• For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump

Control Panel Options

Below are the control panels that can be used with this pump:

• 10-1078
• 10-1106

Note:  Pumps must be operated in upright position.