Zoeller 404-0004, Model E404, Waste-Mate 400 Series, Sewage Pump, 2 HP, 230 Volts, 1 Phase, 12.9 Amps, 4" Flanged Discharge, 300 GPM Max, 33 ft Max Head, 20 ft Cord, Manual, Single Seal

FEATURES

Zoeller "Waste-Mate" Sewage & Dewatering Pump

This submersible pump is designed for use in residential or commercial dewatering and wastewater applications and can be used to transfer large volumes of water from parking lots, flooded areas and unscreened raw sewage. The innovative vortex impeller design reduces the risk of clogging and allows each pump to pass 3" spherical solids. Constructed of non-corrodible hardware, these durable cast iron pumps include a powder coated epoxy finish to prevent corrosion. Every pump is designed to provide heat dissipation from the motor for longer life and lower life cycle cost. As with every Zoeller pump, each one is 100% pressure-tested, submerged and run to ensure quality and reliability for years of trouble-free performance. 

Features:

• Corrosion-resistant, powder-coated epoxy finish
• Cast iron base, cap, motor and pump housing
• Oil filled, hermetically sealed, automatic reset thermal overload protected motor
• Non clogging cast iron vortex impeller
• Upper sleeve bearing and lower ball bearing running in bath of oil
• Mechanical shaft seal - carbon and ceramic rotary face seal, with stainless steel wetted parts
• Stainless steel screws, bolts, washers and lifting bracket
• Stainless steel handle for easy installation and removal
• Neoprene square ring & gasket
• 4” horizontal ANSI flanged discharge
• Passes 3” spherical solids
• Maximum temperature: 130° F 
• UL listed, 3-wire neoprene cord and plug
• Hermetically sealed to be watertight and dust-tight
• 100% computerized tested
• For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump

Below are the control panels that can be used with this pump:

• 10-0125
• 10-1023
• 10-1037
• 10-0092
• 10-0093
• 10-1044

Note: Image is illustrative and may not reflect details of actual product.