Goulds 2GA81J2EDX, Submersible Explosion Proof Grinder Pump, 2GAX Series, 6 HP, 200 Volts, 3 Phase, 2" Discharge, 160 GPM Max., 79 ft. Max. Head, Cast Iron Body, Manual, 30 ft. Cord

FEATURES

Gould 2GAX Series Submersible Dual Seal Grinder Pump

This submersible, dual seal, grinder pmp is capable of grinding municipal, commercial and industrial sewage. 

Features

• Cutter system is designed to reduce sewage to a fine slurry
• Cast iron, semi-open, non-overloading multi-vane design impeller with pump-out vanes for mechanical seal protection
• Cast iron, volute type for high efficiency. Adaptable for slide rail system
• Two coat paint system for superior surface protection
• Float Leakage Sensor (FLS): a small internal float switch is used to detect the presence of water in the stator chamber. Standard on all models
• Leakage Sensor Detector Circuit: The FLS, when activated, will cause the patented 24 volt MiniCAS monitoring relay to signal an alarm and, if desired, stop the pump. The MiniCAS 24 volt relay can be ordered separately for installation in a control panel by a UL or CSA certified panel shop or as a built-in option in our control panel
• Maximum temperature rating: 104º F (40º C) continuous duty
• Tandem mechanical seals
• Fasteners are 300 series stainless steel
• Rotating cutter is chrome alloyed cast iron
• Cutter ring is hardened 316L stainless steel
• Cast iron parts are ASTM A-48, Class 35B
• Air-filled, NEMA type B squirrel cage induction motor
• NEMA type B
• Class F, 311º F (155º C) insulated stator winding
• 60 Hertz
• Motor shaft is 431 series stainless steel, taper collet design
• Oversized, pre-greased upper and lower ball bearings
• Power cord is 30 feet standard, single jacket, 6 conductor combination power and control cable. Optional 100 foot lead is available
• Designed for a maximum of 15 evenly spaced starts per hour
• Built-in thermal sensors provide an over temperature signal to the Mini CAS (Control and Status) monitoring relay mounted in the control panel. The Mini CAS can be ordered separately or ordered as an option in our control panel
• Common pump motor shaft and compact seal design permit short overhang minimizing shaft deflection
• Motor casings have integral cooling ribs for maximum heat dissipation
• Shaft mounting is a robust maintenance free design featuring pre-greased ball bearings
• The junction chamber is completely sealed off from the surrounding liquid and incorporates a separate gland assembly with a strain relief clamp
• Also available in optional Explosion Proof construction. Explosion Proof motor listed Class 1, Division 1, Groups C and D. These units are FM approved

• High head and pressure sewage systems for:
  • Municipal
  • Commercial
  • Industrial