Goulds 3AVN35HM07, Aquavar e-ABII, Booster System with Outdoor Controller (3 HP, 208-230V, 1 Phase Input) and eHM Pump, 3 HP, 208-230/460 Volts, 3 Phase, 1-1/4" NPT Suction, 1" NPT Discharge, 7 Stages, 45 GPM Max, 250 ft Max Head
FREE SHIPPING ON THIS ITEM ! Offer applies to the lower 48 states and excludes Alaska, Hawaii, APO/FPO and international orders. Free standard shipping applies to U.S. orders only and to select items that meet UPS Standard Ground container/cube requirements. Free Shipping
Call Toll Free: 800-429-0800
FEATURES
Buy Goulds 3AVN35HM07, Aquavar e-ABII, Booster System @ PumpProducts.com
This AB2 variable speed pump controller and complete booster package provides an economical answer for municipal water district customers with low water pressure. Both domestic and light commercial applications can benefit. As water use increases, the controller changes pump speed to maintain pressure. Large supply tanks are eliminated and less wear and tear on your pump and motor. Think of it as “Cruise Control” for your pump!
Package includes:
- Pump, model e-HM, 7 stages
- 3 HP intelligent controller, NEMA 3R, model Aquavar IPC
- Transducer, (tank not included)
Aquavar IPC Controller Features
- Input power 200V to 240V ±10%, single phase (low input voltage may affect motor operation)
- Output power up to 230V three phase (based on input voltage)
- Maximum output current is 10.6 amps
- Keypad, LCD graphical display
- Signal lights when power on, inverter stopped, standby, warning/alarms; auto ON
- Over 95% at full load electrical efficiency
- Motor protection against ground fault, motor stall, over temperature, condensation, overload
- Pump protection against no-flow, under pressure, no water / loss of prime, short-cycle
- Ambient temperature is 34º F to 114º F
- Maximum humidity is 93% at 114º F, non-condensing
- Avoid mounting in areas with excessive dust, acids, corrosives and salts
- Outdoor, NEMA 3R, enclosure
- Wall mounted
- Convection with cast aluminum heat sink, with temperature fan
- Transducer is 4-20 mA power supply, 300 psi range, 16-foot shielded cable
Pump e-HM Features
- 3 HP, three phase, 208-230/460 volts
- Flows up to 45 GPM
- Heads up to 250 ft
- Close-coupled horizontal multi-stage design with NPT threaded inlet and outlet connections
- High-efficiency motor coupled with an innovative hydraulic design allowing less pump for more performance
- Built to withstand heavy-duty applications in industry
- Made of 316 stainless steel and construction incorporating a 20% increase in the pump body thickness to ensure enhanced durability and reliability
- Offers a potential of 30% in energy savings versus the competition
- Standard TEFC (IP55) motor enclosure can be paired with Goulds variable speed drives such as Hydrovar
- Almost silent, even when it’s working at its peak due to high-efficiency hydraulics, motor and thick metal pump body
Applications
- Low water pressure applications
- Domestic and light commercial applications
- Homes with multiple showers/baths
- Irrigation
Photo is illustrative and may not reflect the actual product.
The Goulds Aquavar e-ABII; Booster Pump is a popular package kit for larger residential and light commercial applications with low to mid-range head requirements. The package can come in a variety of configurations, but each package will include the e-HM pump model (some will be multistage), a variable speed intelligent controller and a transducer to measure the pressure within a system. Packages that include the expansion tank (pictured right) will also feature a compact one piece e-HM pump. The Goulds 1HM and Goulds 3HM pump models with this package can contain sizes up to 6 stages while Goulds 5HM models can reach up to 5 stages.
Goulds Aquavar e-ABII Booster Pump (Tank Included)
The other Aquavar package without the tank (pictured below) will feature a sleeve design pump with separate suction housing. 1HM and 3HM pumps of this type will have at least 7 stages, while the 5HM pumps have at least 6 stages. The difference between the compact pumps and the sleeve pumps is in the maximum working pressure each can handle. Compact pumps can handle up to 145 psi (pounds per square inch) while sleeve pumps can handle up to 230 psi. The intelligent controller works by sensing water use and adjusting the speed of the motor accordingly. The controller can also regulate the motor through remote commands and monitors the system to alert you of any hazards. Goulds advertises the system as “cruise control for your pump.” Each includes a power cord. Some can be wall mounted. Be sure to install the controller in the proper enclosure based on its rating. Models in this series can reach heads ranging from the Total Dynamic Heads ranging from 25 ft. at the low end to over 250 ft. at the high end. Please note that as these are Booster Pumps, they have no lift capability and should not be run dry. Do not deadhead the pumps. All pumps motors listed below run at 208-230/460 voltage and operate with three phase power.
| Goulds Aquavar e-ABII Series Booster Pump |
| Model | Disch. | Suc. | HP | St. | GPM | TDH | Encl. | Tank |
| 1AB21HM06 | 1" | 1" | 1 | 6 | 12 | 170 | 3R | 2 |
| 1AB21HM04 | 1" | 1" | 1 | 6 | 12 | 112' | 3R | 2 |
| 1151AB21HM04 | 1" | 1" | 1 | 4 | 12 | 115' | 3R | 2 |
| 1151AB21HM06 | 1" | 1" | 1 | 6 | 12 | 170' | 3R | 2 |
| 2AB21MC1G2A2 | 1" | 1.25" | 2 | 6 | 32 | 135' | 3R | 2 |
| 2AB210HM02 | 1.5" | 1.25" | 2 | 2 | 75 | 110' | 3R | 4.5 |
| 2AB22MS1G2D2 | 1.5" | 1.25" | 2 | 5 | 112 | 80' | 3R | N/A |
| 2AB23HM06 | 1" | 1" | 2 | 6 | 23 | 212' | 3R | 2 |
| 1AB25HM03 | 1" | 1" | 1 | 3 | 45 | 105' | 3R | 4.5 |
| 1151AB25HM03 | 1" | 1.25" | 1 | 3 | 45 | 105' | 3R | 4.5 |
| 2AB25HM04 | 1" | 1.25" | 2 | 4 | 45 | 142' | 3R | 4.5 |
| 2AB25HM05 | 1" | 1.25" | 2 | 5 | 45 | 178' | 3R | 4.5 |
| 2AB25HM06 | 1" | 1.25" | 2 | 6 | 45 | 212' | 3R | 4.5 |
| 3AVN110HM03 | 1.25" | 1.5" | 3 | 3 | 75 | 168' | 1 | N/A |
| 3AVN310HM03 | 1.25" | 1.5" | 3 | 3 | 75 | 168' | 3R | N/A |
| 3AVN15HM07 | 1" | 1.5" | 3 | 7 | 45 | 250' | 1 | N/A |
| 5AVN110HM04 | 1.25" | 1.5" | 3 | 4 | 75 | 223' | 1 | N/A |
| 5AVN12MS1J2K2 | 1.25" | 1.5" | 5 | 5 | 142 | 136' | 1 | N/A |
| 5AVN110HM05 | 1.25" | 1.5" | 5 | 5 | 75 | 280' | 1 | N/A |
| 5AVN115HM03 | 1.5" | 2" | 5 | 3 | 127 | 205' | 1 | N/A |
| 3AVN35HM07 | 1" | 1.25" | 3 | 7 | 45 | 250' | 3R | N/A |
| 5AVN310HM04 | 1.25" | 1.5" | 5 | 4 | 75 | 223' | 3R | N/A |
| 5AVN32MS1J2K2 | 1.25" | 1.5" | 5 | 4 | 142 | 136' | 3R | N/A |
| 5AVN310HM05 | 1.25" | 1.5" | 5 | 5 | 75 | 280' | 3R | N/A |
| 5AVN315HM03 | 1.5" | 2" | 5 | 3 | 127 | 205' | 3R | N/A |
| PERFORMANCE CURVES |
| BROCHURE |
| Goulds Aquavar e-ABII General Brochure |
| Goulds Aquavar e-ABII Technical Brochure |
| Goulds e-HM Multistage Pump Technical Brochure |
| Goulds Aquavar Intelligent Pump Controller Brochure |
| GUIDES |
| Goulds Aquavar ABII Quick Start Guide |
| Goulds Aquavar Intelligent Pump Controller Start Up Guide |
| OVERVIEW |
| Goulds Aquavar ABII Product Overview |
Pump Products application engineers are standing by to help you find the right pump, as well as to provide price quotes, stocking availability and shipping information. Call our toll free number 1-800-429-0800 to speak to an expert today.
Call Our Sales Counter For Assistance, Price Quotes, Availability & To Place An Order
Inspector Pumphead & Our Customer Service Representatives Are AvailableMon-Fri 7:30 am to 5:00 pm EST
Call Toll Free: 800-429-0800
*Note: Picture is illustrative and may not reflect the actual product.*
