SJE-Rhombus 1017667, 30DFMMD2WOP, Double Float Master Series, Wide Angle Pump Switch without Plug, Normally Open, 240 Volts, 15 Amps Max, 30 ft Cord

FEATURES

SJE Rhombus Double Float Master Pump Switch

Mechanically activated switch designed to control pumps up to 15 FLA, 90 LRA at 240 VAC. This pump switch is well-suited for confined applications requiring an accurate pumping range, and it is not sensitive to rotation or turbulence. The Double Float  Master pump switch consists of two mechanical floats and a splice tube. The splice tube contains a holding relay which enables the floats to function in series. The holding relay eliminates pump chatter in turbulent conditions allowing the Double Float Master pump switch to operate relay control panels for larger pump applications.

This switch is voltage sensitive - use with correct voltage.

Applications

Normally open to pump down or empty in:

• Non-potable water
• Sewage

Features

• For use with 240 VAC, 50/60Hz, single phase pumps within specified amp ratings below:
• 15 FLA (Full Load Amps)
• 90 LRA (Locked Rotor Amps)
• Adjustable pumping range of 3 to 48 inches
• Cable attached to float housing - flexible 18 gauge, 2 conductor (UL, CSA) SJOW, water-resistant (CPE)
• Cable above splice - flexible 14 gauge, 3 conductor (UL, CSA) SJTW, waterresistant, thermoplastic
• Float dimensions (2.74" diameter x 4.83" length)
• Floats are made of high impact, corrosion resistant, PP housing for use in sewage and non-potable water up to 140°F
• Includes standard mounting clamps and boxed packaging
• Floats are labeled for ease of installation
• Reliable, mechanical alternative for areas restricting the use of mercury
• CSA certified
• Three-year limited warranty

Note: This switch must be used with pumps that provide integral thermal overload protection.