SJE-Rhombus 1046921, 10MAPWPCNCEZ, EZconnex Series, Wide Angle Control Switch without Plug, Normally Closed, 5/30 VDC or 125 VAC , Pipe Clamp Mounted, 10 ft Cord

FEATURES

SJE Rhombus EZconnex Control Float Switch

This mechanically-activated switch is designed to activate pump control panels in low current applications. This control switch is Normally Closed (low level), which means it turns on (closes) when the switch drops below horizontal signaling a low level, and turns off (opens) when the switch tips above horizontal.

Features

• Rated at 125 VAC within specified amp ratings below:
• 1 amp maximum electrical load
• 0.160 milliamps minimum electrical load
• Rated at 30 VDC within specified amp ratings below:
• 1 amp maximum electrical load
• 0.160 milliamps minimum electrical load
• Rated at 5 VDC within specified amp ratings below:
• 1 milliamps minimum electrical load
• Mechanically-activated, snap action contacts
• Maximum water depth is 30 feet or 13 psi
• High-impact, corrosion resistant, polypropylene housing for use in sewage and water up to 140°F
• Cable is flexible 18 gauge, 2 conductor (UL, CSA) SJOW, water-resistant (CPE)
• Float dimensions (2.74" diameter x 4.83" length)
• Quick release float connection simply plugs into manifold port(s)
• Red colored cap indicates Normally Closed
• 4" activation angle above/below horizontal
• Includes a protective rubber boot that provides a dual seal design for an extra layer of protection to keep connections clean and dry
• CSA certified
• Five-year limited warranty

Notes:

• This control switch is designed to use with EZconnex Float Switch Connection Systems:
• 1047612     1047613     1050843    (3-Port connection)
• 1053987     1053988     1053989    (4-Port connection)
• This control switch is for applications where the switch can be attached to a discharge pipe or similar mounting device. Do not suspend floats directly from manifold.