Blog

Features:

• Pressure Switch Pre-Set: 30-50 PSI
• Automatic pressure regulator features a faster-acting and quieter design that eliminates “hunting” for correct drive pressure
• New improved stem and guide are precisely molded to assure efficient, trouble-free performance on all deep wells.
• Close-grained cast iron pump body is a rugged, one-piece unit
• Drain port provided for easy winterization.
• Precision machined diffusers for faster priming
• Precision lapped and highly polished carbon-ceramic mechanical shaft seal, stainless steel construction. Internal design guarantees continuous water lubrication for maximum protection
• Polycarbonate impellers are precision molded for perfect balance, and ultra smooth for highest performance and efficiency
• Motor windings with superior insulation materials to protect against excessive moisture and contaminants
• All electrical components are protected from dirt, dust and insects by a dustproof canopy
• Ventilating air cannot contaminate vital switching components
• This eliminates the most common cause of motor failure
• Rotor is die-cast under high pressures for uniform performance and greater efficiency, dynamically balanced
• Heavy-duty ball bearings, shielded and permanently lubricated, are extensively tested to ensure extended life and smooth quiet operation
• One piece threaded shaft for positive impeller drive and alignment
• Shaft is stainless steel for maximum corrosion resistance