Sta-Rite HMSE-1FL, Horizontal Multi-Stage Jet Pump, HMS Series, 1 HP, 115/230 Volts, 1 Phase, 2 Stages, 1-1/4" NPT Suction, 1" NPT Discharge, 1" NPT Drive, Cast Iron Body
SKU #: HMSE-1FL
Brand: Sta-Rite
Available For Order! ((Usually Ships 3-5 Days))This product is direct shipped from the manufacturer to our distribution center where it is checked, packaged and processed by our quality control team. The estimated shipping time of 7 to 21 days may vary depending on the manufacturer stock, backlogs or delays. To confirm manufacturer lead time for this item, call our Pump Products sales representatives at 800-429-0800 between the hours of 7:30 A.M. - 4:30 P.M. E.S.T. FREE SHIPPING ON THIS ITEM ! Offer applies to the lower 48 states and excludes Alaska, Hawaii, APO/FPO and international orders. Free standard shipping applies to U.S. orders only and to select items that meet UPS Standard Ground container/cube requirements. Free Shipping
Some manufacturers require internet retailers to display a price at or above manufacturers established MAP ("Minimum Advertised Price").
Since our price for this product is lower than MAP, the manufacturer does not allow us to display our lowest price until you place the product in the shopping cart. This allows us to continue offering our lowest prices while staying consistent with product manufacturers policy.
This process does not require you to purchase the product - it can be easily removed from shopping cart if needed.
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Call Toll Free: 800-429-0800
"Ask Inspector PumpHead"
Our Friendly Staff At PumpProducts.com Can Assist You In Placing Your Order.
Sales Representatives Available!
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
This convertible jet pump, series HMS, utilizes a built-in regulator, offering easier priming and better range of performance from a complete line of shallow well, 4" double pipe, 2" and 3" single pipe jet packages. Pump may also be operated as a self-priming centrifugal (to 25 ft) to provide a wide range of high pressure applications. The HMS series multi-stage jet pumps are the highest performing pumps available in its category.
Please note that if using this pump for NEW INSTALLATIONS, a jet assembly package and an automatic pressure regulator PKG 107 must be purchased separately (see brochure in Manuals tab for choosing the appropriate jet assembly).
Features
Close-grained cast iron pump body is rugged, one-piece unit, specially treated to resist corrosion
Precision-lapped and highly polished carbon-ceramic mechanical shaft seal with stainless steel construction. Internal design guarantees continuous water lubrication for maximum protection
Precision molded polycarbonate impeller for perfect balance and ultrasmooth for highest performance and efficiency
Motor windings with superior insulation materials protect against excessive moisture and contaminants to ensure prolonged motor life
All electrical components are protected from dirt, dust and insects by a dustproof canopy. Ventilating air cannot contaminate vital switching components eliminating the most common cause of motor failure
Dynamically balanced rotor is diecast under high pressures for uniform performance and greater efficiency
Heavy-duty ball bearings are shielded and permanently lubricated, extensively tested to ensure extended life and smooth, quiet operation
Pump and motor shaft are made of stainless steel for maximum corrosion resistance; one-piece threaded shaft for positive impeller drive and alignment
Suction port: drive-over-suction
Applications
Ideal to use in water systems and sprinkling for:
Homes
Farms
Cottages
Notes
Pumps installed with a Pro-Source tank require a 100 psi relief valve*
Pumps installed with a conventional tank require a 75 psi*
* Relief valve must be capable of relieving entire flow of pump at relief pressure
"Ask Inspector PumpHead"
