Zoeller 915-0006, Simplex Grinder Basin Package, with Shark Model 803 Grinder Pump, Piggyback Switch, (24" x 24") Poly Molded Basin, 1/2 HP, 115 Volts, 1 Phase, 1-1/4" Discharge, 32 GPM Max, 26 ft Max Head, 15 ft Cord, Automatic

FEATURES

Zoeller 915 Preassembled Simplex Sewage Package

This complete and job ready grinder package is for indoor use in residential wastewater applications or 2" sewage ejector retrofits. 

Package includes

• Automatic grinder pump model BN800
• 24" x 24" poly molded basin
• Steel cover with 2" vent, 1-1/4" discharge and stainless steel bolt kit
• 1-1/4" check valve with unions
• All internal PVC piping factory installed
• Preset float switch and alarm model 10-1494

Package Features

• Automatic, 1/2 HP Shark grinder pump
• 24" x 24" polyethylene molded basin with simplex steel cover
• On: 11" , Off: 5-1/4"
• 4" predrilled inlet
• IBAD - Integral Baffling and Deflection System allows solids up to 4" to enter the basin without becoming lodged; minimizes potential float obstruction
• Basin Scouring System automatically agitates standing liquid to prevent grease and sludge build up. Engineered for the life of the system; no moving parts to wear out

Pump BN800 Features

• Automatic, 1/2 HP, 115 Volts, 60 Hz
• Tri-Slice cutter technology - three independent cutting channels provide over 250,000 cuts/minute
• Grinds flushable wipes, sanitary napkins, disposable and cloth diapers
• Stainless steel cutter and plate
• 15 ft power cord
• 26 ft shut-off head
• Stainless braided lift handle standard
• 1-1/4" NPT discharge can be adapted to existing 2" piping systems
• Automatic thermal overload
• Maximum operating temperature 130°F
• Cast iron motor housing and pump housing provides heat dissipation for extended life cycle and durability
• Small footprint and practical pumping cycle eliminates concerns about short cycling and premature pump failure
• No control panel required. Internal start components
• Upper and lower bearings provide smooth operation and durability in the harshest environments
• Single piggyback switch

Note:  For 2" sewage ejector retrofit, simply remove and discard basin. Cover and suspended grinder pump will drop into existing basin. Cover may require field alignment to support reduced debris build up.