Deming 5560, 5560 Series, Vertically Split End Suction Design, Pollution Control, 60 Hz, NEMA Motor, C NEMA Code, Cast iron
Deming 5560, 5560 Series, Vertically Split End Suction Design, Pollution Control, 60 Hz, NEMA Motor, C NEMA Code, Cast iron
SKU #: 5560
Brand: Deming
Available For Order! (Ships Direct From Manufacturer)This product is direct shipped from the manufacturer. The estimated shipping time may vary depending on the manufacturers stock, backlog or delay. If you would like to confirm the manufacturers lead time for this item, call our Pump Products sales team at 800-429-0800 between the hours of 7:30 A.M. - 4:30 P.M. E.S.T.
Some manufacturers require internet retailers to display a price at or above manufacturers established MAP ("Minimum Advertised Price").
Since our price for this product is lower than MAP, the manufacturer does not allow us to display our lowest price until you place the product in the shopping cart. This allows us to continue offering our lowest prices while staying consistent with product manufacturers policy.
This process does not require you to purchase the product - it can be easily removed from shopping cart if needed.
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Call Toll Free: 800-429-0800
"Ask Inspector PumpHead"
Our Friendly Staff At PumpProducts.com Can Assist You In Placing Your Order.
Sales Representatives Available!
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Deming Vertical Process pumps are space saving, always primed, with cantilever shaft, no submerged bearings, and broad capacity range.
Features:
Casing– Vertically split, end suction design. Double volute type on pumps with 3” and larger discharge.
Impeller– Series 5560 pumps have semi-open type impeller with heavy vanes for outstanding performance. Back pump-out vanes on a semi-open impeller reduces pressure behind the impeller and limits axial thrust.
Power Frame– Heavy duty, one piece cast iron, precision bored and machined to assure alignment of the rotating assembly. Series 4310-11 pumps are short set design. Series 5560 are available in 9”, 12”, and 15” extension lengths below the support plate.
Shaft– High strength shaft is extra heavy for maximum loads with minimum deflection. Impeller is keyed to shaft and locked with impeller nut or large cap screw.
